A weekend at AGD Europe

Shh don't tell AGD(E) but I 'scooped' some pics while I was there working on the C&C extremes this weekend just gone. ... Firstly we spent the weekend just sorting out how we would run production on the new extremes's, this means no new fancy gun pics to show you but you get to see my attempt for 'jig of the year award' It's a masterpiece... It should allow me to write programs from afar for AGDE and also fit all of the parts that require machining for the whole Extreme into one 'easy s...

You mean this one...

It's really not that hard to do, just take your time and go at it carefully. It's an advantage if you have a mill at your disposal but can be done with hand tools. The hardest part is breaking through from the top of the frame so that you can connect to the circuit board in the grip. Screw the grip onto a piece of wood via the bottom line screws and then drill down into it from above. A drill press would help! The only pain is working out what to do with the...

Ok So quite a few people have asked me about where they can mill and how much, so what I have done is created some images which give you a better idea of where the material is and is not. I've taken the outside surfaces and made them translucent (I wish I could do that to people's clothes... but I digress). It takes a little looking at to understand but I hope it helps. You can see the ghost of translucent outer surfaces and then the solid colour of the inner surfaces. You can see the main va...

Hi Guys,

I thought some of you that are more technically minded might like to see what the C&C Extreme's and the NC paths look like while I am programming them. Here is a screen shot

The dark lines are NC paths. This one is actually the second design. The pattern you can see on the side is how we got the aztec look, but that's not what it is here. Here that is just a quick way to rough off the extra material before the finishing programs (not seen). You can see...

OK so I'm back from the World Cup now and so after unpacking my camera tried to take pictures of the trigger for you all It's actually very difficult. This thing is so shiney that I just get glare and reflection off of it with any flash, and in the current indoor/winter night light I can't get any great pictures without a flash... But I took some anyway so you can see it and when I get chance to put it in natural light I will take some more. I had it in my z-grip but that's a bit battered no...

Who says you can't use co2 on an Angel





manike...

I though it was time to resurrect Fight Club, but this time It's level 10 versus...

We've seen level 10 take on 2-3 bounce fresh paint, we've seen it take on TK's tongue... well now here