emag not dry firing?

[DeuceSV]

So I've got my emag completely finished. Its my first one. Xvalve with lvl ten. No air leaks. I gas it up and the air is clearly resetting the trigger, but it is not dry firing. Should it? Is the velocity too low? Too high? Do I just need to put paint in it? Will it fire then?

Thanks,
Jason

[BigEvil]

Turn the velocity up and report back soldier.

[DeuceSV]

Turn the velocity up and report back soldier.

I'm scared to turn the velocity adjuster too far to the right into the back of my xvalve. Possible?

[BigEvil]

I'm scared to turn the velocity adjuster too far to the right into the back of my xvalve. Possible?

Turn it in clockwise. If you go to far, it will vent air. Then back it off a bit.

[DeuceSV]

So I did all of that... I turned it completely to the right... no venting... I turned it completely to the left until it came out... STILL nothing... not even vent leaking.

[TwilightG]

Are you testing in Mech or E mode?

[DeuceSV]

E-mode.

[211]

Is the noid trying to fire, if you have the grip off does the noid move at all?
It could be the magnet in your trigger, flip it around and try it out

[DeuceSV]

everything is moving in the grip. the magnet is doing its job.

[211]

Does it fire in mech mode?

[DeuceSV]

it does not

[TwilightG]

So the trigger pin doesn't move at all then once it's aired up?
Is it possible that a bent on/off pin would cause this?

[211]

have you made sure the safety isnt on, the one behind the grips on the frame
I know it sounds stupid, but that was my problem

[DeuceSV]

its off also

[211]

Which on/off pin are you using?
stock is .750
emag on/off pin is .712