emag not dry firing?

[211]

Low input pressure could definitely be your problem, my buddies Myth only outputs 650, so yours might be the same
On the Armageddon, attach it to your tank and gun, then fill with air, then adjust pressure (allen screw in the front) in for more pressure, out for less
900-1000 output is a good place to start
if your planning on running more than 850 into the mag, you might want to consider using braided stainless line instead of macroline

[DeuceSV]

I got the the piece out of the valve but i can't separate the pin from the rest of the pieces. how do I go about that? thanks

[211]

Push it out from the bottom up
the big end goes at the top of the assembly