Emag wont fire

[athomas]

Operating pressure for any mag is about 800psi or higher. The level 7 mags can run down at 650 to 700 psi with the right setup, but they won't be quite as responsive. Level 10 mags definately require the higher end of the air pressure range to work properly, so you should aim for at least 850 psi for a tank output pressure.

I am surprised that your old setup worked with an output pressure that was as low as yours. I suspect the output of your tank is a bit higher than 350 to 400 psi.

[Gabrie.Downs]

Never mind found it, 600 psi minimum.

[Cyco-Dude]

I am having an issue with a brand new x-valve I just bought.

why are you posting this here? start your own thread, that way you don't re-rail someone elses with your issue (which doesn't even have anything to do with the op's topic).

[Tunaman]

What is the operating pressure for a X-valve?

650+ is good. 900 is better. You cant use that low pressure tank.. Let me know if you cant figure it out and I'll get it running for you no prob.

[Tunaman]

why are you posting this here? start your own thread, that way you don't re-rail someone elses with your issue (which doesn't even have anything to do with the op's topic).

He is new here. Please go easy.

[Tunaman]

post something different, get attacked

post something agreeing with someone else, get attacked

eh.

Notice the smiley above? I did.