Gun leaks through the barrel!! PLEASE HELP

[qck95z28]

im not familiar with too many internal valve problems as i havent had many. I'm not sure what it is, someone else might be able to help, or you might find out if AGD will fix your valve and use one of the 4 stars.

What are those 4 stars any ways? Does every mag have them? What do you mean they will use one of them? Approxamatly how much do you think it would cost if i send it to agd to be fixed? Prolley enough i could buy and x valve and that would fix the problem wouldnt it?

[Ace12GA]

The stars entitle you to one free valve rebuild by AGD, each. There is a little more to it than that, but you can find the details on the AGD's site pretty easy.

Have you gassed it up, fired a shot, and held the trigger yet? This is one of the easiest ways to trouble shoot the difference between powertube and on/off problems. If the leak stops, its a power tube issue. If the leaks continues, its an on/off issue. Very simple.

[qck95z28]

The stars entitle you to one free valve rebuild by AGD, each. There is a little more to it than that, but you can find the details on the AGD's site pretty easy.

Have you gassed it up, fired a shot, and held the trigger yet? This is one of the easiest ways to trouble shoot the difference between powertube and on/off problems. If the leak stops, its a power tube issue. If the leaks continues, its an on/off issue. Very simple.

Yes, and it does both. But normally if i hold it in it will stop, but like I said if it is a stream, it will just slow it down a little. So i can get it fixed for free 4 times if need be? What do i need i wonder since it is a used gun they will still let me send it in. Ill Check it out!!

[rb211]

As far as I know, use of the stars is not limited to the original owner (correct me guys if i'm wrong.) Personally, I wouldn't waste a star until I bought a parts kit and started replacing different o-rings. Mags are incredibly easy to work on and you have a vast resource for troubleshooting here.

I don't know if this has been pointed out to you in previous posts (just skimmed over them), but the order of parts in the power tube is o-ring first, then spacer, then power tube tip. After you replace the ring, play with the spacers until you find the one that doesn't cause a leak. Simple. Unless you have a cracked power tube, the new batch of o-rings should take care of it.

[qck95z28]

It's Fixed!! Yes

I just fixed it. And i cannot get over what it was, it was the o-ring that goes in before the spacer in the powertube. But i could have never figured it out without your guy's help, because i didnt have a manual and it was never there to begin with so... i would have never known. BUT the funny thing is HOW did it work for the 100 shots before? I hope it isnt just a string of luck for the one day, then tommorow i get it out and it does it all over again. Just pray that dosent happen. BUT, THANKS TO ALL WHO HELPED

[rb211]

Here's a link for the automag manual. http://www.airgun.com/Images/automan.pdf Glad to see you got it fixed.