Need beta testers for efficiency inserts

[leloup]

what is the eta, hill?

[hill160881]

Sorry been busy with another non paintball related project.

I am just waiting on the inserts from y0da.

[y0da900]

Sorry been busy with another non paintball related project.

I am just waiting on the inserts from y0da.

On their way finally. Sorry for the delays everybody.

[hill160881]

Thanks y0da900

Arrived today. I will get it all together and send out PMs soon. Looks like the total will be $10ea shipped with a replacement red power tube oring.

[hill160881]

Here are the finished inserts. The one with the oring is the one for the classic.

[Justus]

You have the testers for the X-valve covered, right? If not, count me in and let me know.

And if so, just keep us informed as to the results, reviews, and timetable for release.

[hill160881]

I have 10 of each so there some extras.


I will try to get this all put together tomorrow night.

[Jiker]

Have there been any results reported from this yet?

[hill160881]

To be honest I have been totally warped up and will get to these this weekend. So I will put together a sales thread in the BST section since I got more than signed up as possible testers.

Super sorry for the delays but life happens.

[stevewar]

I'm super excited to test this out!

[sjrtk]

life happens.

Yes it does no big deal just can't wait to get a hold of this to test

[hill160881]

A thread is up in the misc section of the BST now

[hill160881]

Here it is

http://www.automags.org/forums/showthread.php?p=2778130#post2778130

[Venom]

[QUOTE=Pneumagger]Using a Kenametal "Thinbit" or similar parting tool (thinbits can be .030" in width or smaller) just clean the weld out of the weld groove.QUOTE]

I might be wrong, but Kaiser makes ThinBits... http://www.kaisertool.com/

I don't think Kennametal has a comparable product.

[GEE TEE]

Hi Hills,

Ive just picked up an RT Pro valve and which needed stripping to swap a few seals. The front tube unscrewed from it when i tried to remove the power tube tip. Must have only been finger tight. Not sure which insert would work with this valve but i'm happy to give one a try if there's any spare. The red o-ring wasn't damaged so it should re-seal ok