AO: We are back from the dead... again! After an 18 day outage, we are finally alive and well. Who knew how complicated updating software/databases from 2008 would be. I still have alot of tweaks to make, but my main goal was getting everything patched and updated to 2026.
Vbulletin 6 has changed alot since 2008 so we will have a ton of new features to dig into.
Got another crazy printing idea that may just work. If you pay attention to my blabbering, you may know that I just "finished" a Z body pump mag. By finished I mean made it functional, and it's a whole hell of a lot of fun.
An idea struck me. What about making a "classic feed" for where the powertube attaches. The body uses as a dovetailed, removable powerfeed setup. If I can go with a classic feed, I can easily bolt on a very low profile stick feed. Biggest problem is that I'm drawing up a product with a market of one buyer (I think). Then again, I thought 3D printing was all about the capacity to do one offs and rapid prototypes?
So I took to my free CAD software and came up with this. I'm pretty sure this is a printable part, no?
[ATTACH=CONFIG]89668[/ATTACH]
I also made one with a fully revolved and extruded 12 round tube, but that might not be possible to print because of dimensions and geometry? See below.
Comment