New Nummech Gas Thru Frame

[going_home]

Which are you talking about, the one on top of theb ASA or the one in the ASA ?

http://www.nummech.com/media/prod_nmagframe/nmagframe-installation.pdf

[captian pinky]

The one on the asa knob when you completely remove it.

[Bunny]

Is the gap in the gripframe really noticeable?

[captian pinky]

which gap?

[Bunny]

Sorry about that! the gap between the frame and the grips. It looks like there may be a gap depending on the grips used on the frame.

[Kapyrna]

Gap isn't super huge at least on the right side.

[capt spank]

luke's panels cover it

[jarhead86]

Dye Stickies cover it too

[going_home]

Gap isn't super huge at least on the right side.

Nice

[lynxkcg]

Anyone had any trouble with their safety locking up? The ball has deformed the safety pin groove on mine to the point that you can't take it off safety. The safety screw is flush with the top of the frame, I hope I have a lighter spring lying around.

[Ydna]

Email your mailing info to info@nummech and I can send you a new safety button! I'll see if I have any lighter springs, but not sure at that tiny size...but you can always try cutting the spring just a little shorter. Just don't go too short or else it won't work at all

[Laku]

[going_home]

Single trigger frame.

Nice find.

Looks like double and single are in stock too.

http://www.nummech.com/prod_cat_automag.html

[ScottyBeans]

these are siiiick!

[ascinder]

What ever happened to their pneumag kit? It looks like you would have a hard time fitting a normal LPR in there, let alone Luke's. Did anyone ever successfully pneumag a nummech?