The SpyderMAG, Incl a How To

[Xenocide]

sorry, the girlfriend said no green :) plus I don't think it would go with the smoke theme to well. Maybe I'l switch to steel braided hoses and use green heat shrink on them l

[Linkwarner]

That was awesome, It was late when I was surfing the forums last night. When I woke up this morning (or afternoon) I looked at the E99 trigger frame and it was the same one.

[Xenocide]

i think the e99 trigger is even better, since I am pretty sure it is not bps locked. With the lvl 10 you should be good to go up to 23 bps. I would suggest stretching the microswitch spring and taking out the trigger return spring. There is a link to how to stretch the micro switch spring in my how to.

[robdamanii]

All the stock Kingman boards are capped at 13 BPS.

You'd have to be getting an aftermarket board to get higher than that.

[Igotu]

How would a m4 piranha frame work, there a little less spendy then the spider frame?

[madmatt151]

All the stock Kingman boards are capped at 13 BPS.

You'd have to be getting an aftermarket board to get higher than that.

Didn't he replace the board, so it doesn't matter anyway, right? Also, are the eyes necessary? Could I build this without the eyes?

[robdamanii]

Hmm, perhaps he did replace the board.

The stock kingman boards are capped at 13 though, regardless (some are 14).

Eyes aren't necessary.. You don't have to install them. All the aftermarket board work without the eyes, so it would indeed simplify your installation.

[flyinasian016]

Xenocide, i would like to have this mod done to my gun, but unfortunatly im a bit clumsy with tools. Would it be possible for me to send you the frame and my mag and let you install it for a price? PM me and let me know if that would be possible

[Ityl]

http://www.automags.org/forums/showthread.php?t=114036

[Igotu]

to know if it would fit, would i just have to measure it to see if its long enough.

[noahyay]

i know this is an old thread but whatever,

dont have a mill but i did the zap the mad conversion in about 2 hours

need to glue the soleniod in place still

bought an e-dragunfire frome my friend for 60 bucks and used that same frame.

i kept messing up the screw holes and there are some plastic spacers and misc. metal parts holding it on but its nice and sturdy

cant wait to try it out -first i need a ule trigger though

[daviselk]

Is that a pewter clamp feedneck?!?! I need one!

[BigEvil]

Anyone know where I can get parts for the Spyder e-frame? I would like to get an extra sear or two before I start choping away with my dremel.

Thanks

[coofoo777]

hey bigevil, here ya go...
http://www.firstcallpaintball.com/index.php?main_page=product_info&currency=USD&products_id=497

[Resurection]

Your link had extra stuff in it:

http://www.firstcallpaintball.com/index.php?main_page=product_info&currency=USD&products_id=497