G-Force to release pneumatic frames for the Mags

[G-Force Tech]

I am going to mill another version of the LPR that is going to be deeper but not wider so your aftermarkets grips can still be retained.

Garf

[stircrazzzy]

Man, I wish you didn't have the little wing on the back of those frames...

if you ever do another run where the frames look a bit less radical, I'd love to buy one I like the KISS principle with my pneuframes.

[TwilightG]

Man, I wish you didn't have the little wing on the back of those frames...

Are you sure you're not confused with the Airwalk frame?
The G-Force frame is very simple-looking.

[stircrazzzy]

You may be right. In which case I plead stupidity, but you have to understand, I'm on a lot of pain meds right now lol

[UThomas]

Garf- thanks a bunch for the regular updates. Definitely settles the restless natives

[warbeak2099]

I am going to mill another version of the LPR that is going to be deeper but not wider so your aftermarkets grips can still be retained.

Garf

Sweet. Hopefully I'll have my grips and LPR by Tunaball.

[insixdays777]

Garth any luck with the deeper LPR? Thanks for the updates.

[Beemer]

Garf- thanks a bunch for the regular updates. Definitely settles the restless natives

Last Activity: 04-17-2009 05:51 PM

That was over two weeks ago.

[G-Force Tech]

I am redoing some of the CADCAM on the revision and have to revalidate other components before setting the milling to cut a block of alum. The air passage into the high pressure chamber would need to be shift off center to allow for the larger chamber.

I post another update end of week once this is done.

Garf

Garth any luck with the deeper LPR? Thanks for the updates.

[sarge40]

I can't to see verticle adapters!!!!!!!!!

[G-Force Tech]

LPR update

CADCAM drawings done for the new changes on the increased air chamber. It looks like I can boost the volume. Also new grip panels won't be needed.

Garf

[WickedKlown2]

CADCAM drawings done for the new changes on the increased air chamber. It looks like I can boost the volume. Also new grip panels won't be needed.

Garf

Great to hear,,, let us know how it works out !!!

Also looks like I can still use my Kruger black micarta grip panels...

Thank You Garf for the Update

WK2

[warbeak2099]

What happened to the updates?

[sarge40]

I guess the updates went with the verticle adapters.

[warbeak2099]

Hopefully the internal LPR's didn't go the same route.

Garf, what's new?