"Classic Valve and ULT trigger don't mix"... my a**(video)

[electriceel125]

What did you use to make the stop? How did you make it? Thankz

[Glock17]

What are shims? Oh and is this thing pretty easy to install?
$50 for that kinda of firepower..

[Bad_Dog]

if you look on the first page of this thread I posted a diagram on the shims that I use in my setup. The shims themselves are used to controll the length of the ULT on/off setup. The more the shims the less on/off pin exposed and vise-versa... since there are a few different variables between each setup (valve, input pressure, lvl10): the shims allow you to tune the ULT to YOUR setup.

The trigger stops are just set screws drilled and tapped into the trigger.

[jdaniels]

extra shims

where are the extra shims purchased. The ult comes with 3 right. I looked on agd's site and didnt see extra shims. Also do you get your ult from agd or some one else. I would love to try this in my classic, its a pretty cheap upgrade if i can get it to work properly.

thanks

[Glock17]

Yes, where can the shims be purchases and how much. $50 for a upgrade that shoots that fast. Sweet.

[Plazmic]

You get the ULT from AGD. I don't think you can find it anywhere else.

The ULT comes with 2 shims installed and 3 extra, so 5 total...or is it 4 extra for 6 total. Well, one of those two, anyway.

LX shims are like putting in 2 ULT shims. You can get LX shims here:

AGD Store: LX Shims

Regular ULT shims are .005mm thick and Level 10 shims are .010mm thick, so one LX = 2 ULT shims.

I hope that helps.

[Joni]

It comes with 5 shims.

[jdaniels]

okay

they are the same inside and outside diameter as lvl 10 but just thinner than the lvl 10 shims. Is that correct.

[Joni]

Exactly. The ULT shims are 0.005" and the lvl10 shims are 0.010"

[Plazmic]

Yes, same diameter, just half the thickness.

[OysterBoy]

When you buy Level 10, do you get LX Shims? Or, do you but not enough for extra...?

[Plazmic]

Yes, you get extra shims when you buy the LX. It's rare that anyone uses them all. I had 4 LX shims left over, myself.

[Bad_Dog]

I used my extra level 10 shims, I somehow had 4...

[jdaniels]

ordered today

i ordered my ult today. I just installed my lvl X on saturday. I hope to get this work okay. If not i know where to come for help. I am using co2 so this may take some patience. I will keep you guys posted.

[Bad_Dog]

be sure to get that lvl10 fine tuned first, that way when your setting up your ULT, if you encounter a problem... you KNOW its comming from the trigger kit (thus you can fix it faster).

Just helps