mag fsr sniper rifle

I bought this of the AO forums with the intention of doing a box mag type feed. http://www.automags.org/forums/showt...ject&p=2833484 but already having a emag and building a double barrel mag I have enough in the way of rate of fire so decided to do a mag fed marker and then thought why no a fs platform. I sent the ULE body to Xmag Terror after talking to him about it to get the feed port milled out and a new feedneck built to run the fs rounds. got it back very q...

Love it or hate it this is my version of a valve cap for a classic valve.

The hole in the back if for a burst disc to make these safe. caps are side drilled to use a spanner wrench to install them.



note: the uninstalled cap has not yet been drilled.....the one pictured on the valve is the 1st piece off the mill....

This rail design was talked about a few months back, there was some interest at the time so I went ahead and did the prototypes to test the programming. Engraving shown would NOT be standard but an add-on. Rails are ULE milled with foregrip slots. Automag rails would have a duel slot for use with both AGD style VASA's. RTP full length slot for 2 screw VASA. Both rails match factory lengths. Milled for all body styles. RTP is 1.00" wide. AM rail is 0.98" Both rails can be pump milled. ...

Anyone interested in this 'long' version of the Armada?
It uses the RTPro sear and matches the factory length RTP rails.
Foregrip slot and full ULE milling.

RHS


LHS
...

This project has been cooking for quite some time, i think its finally getting to a point worth sharing! I love bullpup designs, i've been trying to figure out how i wanted to go about stuffing an mag into a bullpup format for a while now.

Here is what i came up with:



And because everyone loves build pictures, here are a few pics from the creation process:






...

So this was a project I have been wanting to do for awhile and I actually almost finished this within a week.
Here is my original idea pics:

I originally wanted Macro fittings on the outside and inside, but there wasn't enough room. I ended up going with micro line and I had to do some internal milling to make sure the sear didn't hit the air line. I milled the hole on the right side of the frame, but because of the internal...

Thought i would throw this pic up because i know you guys like seeing new or new versions of things. I made another one of these for an AO memeber.....the one shown is the extra i made. You can find it in the dealers section, in the body super store thread.

AM/MM length ripper body and rail.....only 2 ever made.

...

Here is my Aurora Shockwave E-mag. Build thread coming soon, but I was too excited to wait. Props to Keith and XMT! Enjoy! ...

Check back in 2015!

Welcome to the Tuna Ball section within the AO Archives. Here you will find pictures galleries of the past Tunaball events. If you have any pictures you would like to add feel free to pm Bunny. I would like to thank Redic for all of his pictures throughout the many years that Tunaball has existed....