High Speed Video Ball Dropping Into Breach

Nice idea Mr Grumble but in reality you cannot start feeding the ball in that soon or closing the bolt so soon on a half fed ball. It's because of the actual shape of a sphere it's very limiting in terms of how far in it needs to be fed before you can start closing on it... I calculated it out years ago but to be honest can't remember my figures for how soon you could close the bolt without having a serious risk of chopping the ball... It made only a very small difference. I'll let some p...

OK so here are some pics from the UK indoor championships where Storm UK's pro team came second. I didn't get on the field to take the pics because the fields were small and paint intensive and my pain threshold was feeling low that day (aided by a big night the night before...)

Here's the diablo field...





Here are some pics of a prototype Extreme C&C in use...



Here are some general Storm Pics ...

Shh don't tell AGD(E) but I 'scooped' some pics while I was there working on the C&C extremes this weekend just gone. ... Firstly we spent the weekend just sorting out how we would run production on the new extremes's, this means no new fancy gun pics to show you but you get to see my attempt for 'jig of the year award' It's a masterpiece... It should allow me to write programs from afar for AGDE and also fit all of the parts that require machining for the whole Extreme into one 'easy s...

Mardi Gras Open Trade show pictures featuring a "Xtreme" E-mag, SFL E-mag, and a 1-15~ Red Acid Wash E-mag.

http://www.warpig.com/paintball/tour...h/index2.shtml...

You mean this one...

It's really not that hard to do, just take your time and go at it carefully. It's an advantage if you have a mill at your disposal but can be done with hand tools. The hardest part is breaking through from the top of the frame so that you can connect to the circuit board in the grip. Screw the grip onto a piece of wood via the bottom line screws and then drill down into it from above. A drill press would help! The only pain is working out what to do with the...

Ok So quite a few people have asked me about where they can mill and how much, so what I have done is created some images which give you a better idea of where the material is and is not. I've taken the outside surfaces and made them translucent (I wish I could do that to people's clothes... but I digress). It takes a little looking at to understand but I hope it helps. You can see the ghost of translucent outer surfaces and then the solid colour of the inner surfaces. You can see the main va...

Hi Guys,

I thought some of you that are more technically minded might like to see what the C&C Extreme's and the NC paths look like while I am programming them. Here is a screen shot

The dark lines are NC paths. This one is actually the second design. The pattern you can see on the side is how we got the aztec look, but that's not what it is here. Here that is just a quick way to rough off the extra material before the finishing programs (not seen). You can see...

All, There has been considerable discussion concerning the beta X_mags put out by Europe during the development phase in the past year. The high demand for the marker has driven many customers in the US over to Europe looking to buy these used or new X-mags. These markers present a problem to AGD-US because we do not have the capability to update them and did not make the profit to justify fixing them. In the past this has not been a problem because all the product we sold had identical par...

Guys,

Kayle took these pics at Fox River Games on Sunday. Cliff was there with his super custom babies! These all have either Mags or Spyders inside.

AGD









...

Here is it is!! (note the smile on Chris' face at the end)






AGD...