** Official Level 10 Problems Thread **

[JG2790]

Any advice would be great, someone please respond....

-JG2790

[obtanium]

x valve not workin with me

2 problems....

cant get my marker below 280fps now, and balls still breakin...any advice?....

kinda depressing when you buy something thats suposed to fix your problems and it creates more...

[BD_Paintball]

try a different spring for the velocity problem and for the ball breaking problem try a larger carrier. get the largest carrier that doesent leak. and most ppl use 2 or 3 shims. (i got 2 shims) and what happens when you turn down the velocity or is it all the way out??

[obtanium]

ummm...if i turn the velocity down the marker uncocks\ wont shoot-has to be nearly all the way up to get it to fire...the only spring i can use is the small one.if i switch to another it won't fire at all...ok let me understand this correctly the larger the carrier=better chance of the lx working properly and not break balls?should the valve need oiled right from the factory?

any help is appreciated

[BD_Paintball]

when you put the larger spring in you will have to turn the velocity up. and the larger the carrier (and carrier o-ring) more chance that it will not chop but also more chance it will leak down the barrel. i would say put some oil in the air fitting and then shoot the air through it. but if you put the larger spring in you will have to turn the velocity up to make it shoot.

[SpdElemts]

I just bought a LVL10 and can someone give me instructions on how to tune this? I appreciate it

THanks jeff

[BD_Paintball]

you could go here http://www.automags.org/resource/lev...shtml#detailed

this is where it talks all about the lvl 10

[Lone Brain Cell]

Ok I have had my level 10 running in my powerfeed mag for 12+ monts ,but I have just put a ule on & I keep getting bolt stick, the bolt would just protrude through into where the neck is & stick there bleeding air. Ive tried different spring & no go!!

I am running short spring 2 shimms at the moment.

Help

[SpdElemts]

Reg Piston

Do i need a new Reg. Piston for my new LVL10? I dont have my lvl 10 yet so i cant test it. Im thinking if i need the reg piston i need to order it so i can get it in time for my game. how much more Velocity do i need to shoot with the lvl10?

[BD_Paintball]

whats wrong with you lvl 10 that you would need a new reg. piston?

[SpdElemts]

i have read that sometimes you have to replace the reg. piston because of the higher vilocity that is needed for the lvl 10.

[Ddog740]

Level 10 pressure?

What is the recomended pressure to use through the level 10?

[Evil1]

The input pressure of a mag does not change w/ the installation of the LX. I run my EMag w/ LX at 850psi.

[Stampede15]

N/T

Edit: Figured it out.

[blakdragon21]

Does it really matter what spring you use? I heard that you are suppose to use the middle spring, but I seem to have trouble getting the vavle to work without bolt stick with the middle spring I have to use the small spring. I also heard that the different spring are for like different kinds of paint too. I don't know. If someone can clarify what all the springs are for it would be cool. thanks