Originally posted by Loguzzzzzz
View Post
-
The location of where the cheater must be mounted is the limited factor, I certainly wasn't implying it was impossible, just with my design.
-
Seems to just drop in as long as that area I asked about is the same as a intelli in your frames.Originally posted by luke View PostThere's room, but it will still need machined correct?
Set screws will work but will need to be strategically located to avoid the thinnest part of the ram cavity which is 0.030" thick.
I went with a built in mounting tab so it has a positive and repeatable mount location.Originally posted by dano_____Comment
-
Like I said, the area you ask about on the cheater is 100% irrelevant to mounting it in ANY frame, it's the foot print and depth that is important. (Did you get my email this morning?)Originally posted by cougar20th View Post
It is absolutely crucial that the dimensions are relative to the trigger pin hole and/or the frame screw holes, just having the space is only 1/2 the equation.
Comment
-
Cougar, take the original model I sent you and drop it into your frame, line it up on screw holes, trigger pin, safety holes and flush to the top, whatever does not fit into your frame will need to be machined away (On your frame)...Comment
-
Would this frame work with a PTP micromag and an xvalve?Comment
-
Did more testing today and found a small issue, that is, small being relative to the whole scope of the project. (lol)
I will have to tweak the entire design, reprogram and machine another prototype. (So glad I did some testing... again>>>
)
What's interesting is it was a single, solitary bit of information I trusted from an outside source that went unverified until today. It's completely my fault though because I went against my #1 cardinal rule......
So it's back to work, it will be a few days before there are any more updates.Comment
-
OK I get it now. Miss understood.Originally posted by luke View Post
M86's will need to be machined to fit this.Originally posted by dano_____Comment
-
Bingo! I had a feeling we weren't on the same page.Originally posted by cougar20th View Post
Do you have the intelli frame modeled?Comment
-
-
Ill pm you shortly about itOriginally posted by luke View PostBingo! I had a feeling we weren't on the same page.
Do you have the intelli frame modeled?Originally posted by dano_____Comment
-
I understand that this is purpose built for your frame only. I never said you said or were implying any such thing. I was trying to answer some other interested people's question, that is all.Originally posted by luke View PostThe location of where the cheater must be mounted is the limited factor, I certainly wasn't implying it was impossible, just with my design.......You know you want one!!Comment
-
unless cost is quite low,
does it make sense to buy this for any other frame other than a lukes frame?Comment
-
I see it as a price point issue along with how much work it would take to make it work, and at what cost to make it cost effective for any other frames. From what I recall the Zap Cheater was about $100. Now if you lack the know how and the skill to mod a frame then I see the other alternative as a better option. If you have a luke frame then this is definitely a viable option. . . . . but at what cost. This still remains to be seen.Originally posted by knownothingmags View Post......You know you want one!!Comment
-
I could be for one, depending on price, to mount on your vert frame, or a M86. But most probably on my armada's vert frame.Last edited by maverick13; 03-04-2015, 03:53 PM.Comment
-
Comment