** Official Level 10 Problems Thread **

[pepper]

Im glad it wasnt a snake, thanks man.

[secretweaponevan]

I have a PTP Micromag
Inteli frame
Retro valve
LvL 10 bolt setup.

I'm just looking for a step by step process on how to install the LVL 10. If I run into any problems I know I can ask in this thread- but for now I cant seem to find a "how to" on the LVL 10.





Thanks
Pep

Up top of the forums.
[RESOURCES ]
[Level 10 Guide ]

That and youtube: http://www.youtube.com/watch?v=V0mvr30jKhw

[pepper]

I have a PTP Micromag
Inteli frame
Retro valve
LvL 10 bolt setup.

I'm just looking for a step by step process on how to install the LVL 10. If I run into any problems I know I can ask in this thread- but for now I cant seem to find a "how to" on the LVL 10.





Thanks
Pep

[athomas]

just got my micro back from AGD...it had :
* ule trigger kit installed
*x-valve with level 10 installed
settings : x-valve: gold spring,carrier #1, 3 shims...
ule: no shims

problem is sometimes when gun fired...trigger goes dead and it looks like the bolt is not returning back all the way...if i look through the ball feed i can see the leading edge of the bolt sticking outward slightly.
Now...is it a level 10 problem or ule problem?
using a pure energy 3000 psi 48 cu tank..hoping to fix this on my own...live in canada and really dont wanta have to ship it back to roman

The fist thing to do is remove all the level 10 shims from the powertube. Then use the largest carrier that does not leak. Always use the same white powertube oring in each carrier that you try. Once you get that done, try firing your gun to see if the same thing happens. If it does, then you move onto the ULT setup.

The problem with the micromags, is that the on-off pins are typically shorter than a regular mag on-off pin. On a typical retro mag, you use between 4 - 6 ULT shims. That translates to .020" to .030" of adjustment. Some micromag spacing differences cause the ULT to already have that much equivalent length added to the assembly, which is why it probably was shipped to you with no ULT shims installed. Once you get the level 10 tuned, play with the ULT. All you can do is add shims until you get a runaway effect. Then remove the 1 or two shims that caused it.

The ULT shims are 0.005" thick. The level 10 shims are 0.010" thick. Don't get them mixed up.

[jr50hockey]

stumped

just got my micro back from AGD...it had :
* ule trigger kit installed
*x-valve with level 10 installed
settings : x-valve: gold spring,carrier #1, 3 shims...
ule: no shims

problem is sometimes when gun fired...trigger goes dead and it looks like the bolt is not returning back all the way...if i look through the ball feed i can see the leading edge of the bolt sticking outward slightly.
Now...is it a level 10 problem or ule problem?
using a pure energy 3000 psi 48 cu tank..hoping to fix this on my own...live in canada and really dont wanta have to ship it back to roman